1-pair DIN rail plug-in Telecomsurge protector

DLA-170
Part Number: 6406011
DLA-170
  • Din rail plug-in surge protector
  • 1-pair
  • Uc : 170 V
  • Shield wire protection
  • Without line cut-off
  • IEC 61643-21 compliance

DLA surge protectors are designed to protect, against surge voltages due to lightning, terminals equipment connected to industrial buses, telecom lines or datalines. These surge protectors must be installed on symmetrical DIN rail and are available for most of the transmission lines: line voltage from 6 to 170V, bitrate up to 10 Mbit/s. D3 types aim to realize fine protection and D2 types is specific for floating application. These products are 1-pair surge protectors with removable module for easy maintenance.


Network
RTC, ADSL2, VDSL2
Nominal line voltage
Un 150 V
Max. DC operating voltage
Uc 170 Vdc
Max. frequency
f max. > 10 MHz
Insertion loss
< 1 dB
Max. load current
IL 300 mA
Max. discharge current
max. withstand @ 8/20 µs by pole
Imax 20 kA
Line inductance
No
Protection level
Following the test category C3 (IEC61643-21) - Line/Line
Up 220 V
Protection level
Following the test category C3 (IEC61643-21) - Line/PE
Up 20 V
Impulse current
2 x 10/350µs Test - D1 Category
Iimp 5 kA
Nominal discharge current
C2 Category
In 5 kA
Line resistance
< 4.7 Ohm
Technology
GDT+Clamping diode
SPD configuration
1-pair+shielded
Connection to Network
By screw terminal: cross section 0.5-2.5mm²
Mounting
Symmetrical rail 35 mm (EN 60715)
Housing material
Thermoplastic UL94 V-0
Protection rating
IP20
Failsafe mode
Short-circuit
Spare module(s)
DLAM-170
Dimensions
See diagram
Standards compliance
IEC 61643-21 / EN 61643-21 / UL497A